Search results for "I–V characteristic"
showing 6 items of 6 documents
A procedure to calculate the five-parameter model of crystalline silicon photovoltaic modules on the basis of the tabular performance data
2013
Abstract Only few manufactures provide the wide set of graphical data that are necessary to use high performance predictive tools for PV systems. On the other hand, reliable graphical data require accurate laboratory measurements that increase manufacturing costs. For this reason PV system designers have to choose between the use of cheap PV modules, lacking in technical data, and the reliable energy predictions that are possible only if the current–voltage characteristics are provided by the PV module manufacturers. This paper describes the procedure to evaluate the parameters of a one-diode equivalent circuit able to accurately represent the electrical behaviour of a PV panel by means of …
An improved five-parameter model for photovoltaic modules
2010
This paper presents a new five-parameter model capable of analytically describing the I–V characteristic of a photovoltaic module for each generic condition of operative temperature and solar irradiance. The parameters of the equivalent electrical circuit are extracted by solving a system of equations based on data commonly issued by manufacturers in standard rating conditions with a trial and error process. The procedure, which does not require any special equations solver, can be easily coded into a short software routine using simple languages and finds the solution of the system of equations with the desired accuracy without needing to be guided towards solutions starting from fitted in…
On the experimental validation of an improved five-parameter model for silicon photovoltaic modules
2012
Abstract This paper presents the experimental validation of a new five-parameter model capable of analytically describing the I–V characteristic of a silicon photovoltaic module for each generic condition of operative temperature and solar irradiance. The operating current calculated with the model was validated on the basis of a series of experimental measurements performed in the field on two commercial silicon photovoltaic panels connected to a set of nine constant values of the electrical load. In order to examine the panels working in almost steady-state conditions only the data-sets of the sunniest days from sunrise to sunset were used. Unfortunately the production spread of photovolt…
A procedure to calculate the I–V characteristics of thin-film photovoltaic modules using an explicit rational form
2015
Abstract Accurate models of the electrical behaviour of photovoltaic modules are effective tools for system design. One or two diode equivalent circuits have been widely used even though some mathematical difficulties were found dealing with implicit equations. In this paper, a new model based on a simple rational function, which does not contain any implicit exponential form, is presented. The model was conceived in order to be used with thin-film photovoltaic modules, whose current–voltage curves are characterised by very smooth shapes. The parameters of the model are evaluated by means of the derivatives of the issued characteristics in the short circuit and open circuit points at standa…
A comparison of different one-diode models for the representation of I–V characteristic of a PV cell
2014
Predictive performance tools are an important factor in the success of any new technology because they permit demonstration of whether a system will be efficient and economically feasible. A reliable predictive tool should allow the designer to optimise system performance and to maximise the cost effectiveness of a system prior to installation. This article discusses the five main parametric models for photovoltaic (PV) systems available in the literature. The current–voltage characteristics of a photovoltaic module can be reproduced modelling the PV panel as an equivalent electrical circuit made of linear and non-linear components. The parameters describing such components are directly rel…
Corrigendum to “A procedure to calculate the five-parameter model of crystalline silicon photovoltaic modules on the basis of the tabular performance…
2014
Only few manufactures provide the wide set of graphical data that are necessary to use high performance predictive tools for PV systems. On the other hand, reliable graphical data require accurate laboratory measurements that increase manufacturing costs. For this reason PV system designers have to choose between the use of cheap PV modules, lacking in technical data, and the reliable energy predictions that are possible only if the current–voltage characteristics are provided by the PV module manufacturers. This paper describes the procedure to evaluate the parameters of a one-diode equivalent circuit able to accurately epresent the electrical behaviour of a PV panel by means of the minimu…